Blog List
Copper Plating Aluminum: What CNC Buyers Should Check Before Production
Copper plating aluminum sounds like a simple surface finish. A buyer may need a copper-colored surface, an electrical contact area,…
Bead Blast Surface Finish Chart for CNC Machined Parts
Bead blasting is often used when a CNC machined part needs a more uniform matte appearance. It can reduce the…
Flatness Tolerance Per Unit Length for CNC Machined Parts
Flatness looks simple on a drawing, but it can become one of the most misunderstood requirements in CNC machining. A…
Press Fit Tolerance for CNC Machined Parts: Design and Inspection Notes
A press fit looks simple on a drawing: one shaft goes into one hole, and the two parts stay together…
17-4 PH Stainless Steel Machining: Heat Treatment, Tolerances, and Finish
17-4 PH stainless steel is not just another stainless steel grade for CNC machining. It is a precipitation-hardening stainless steel…
CNC Turning Parts: Design Features, Materials, and Inspection Points
CNC turning parts look simple until the drawing includes a tight bore, a long slender shaft, a thin sleeve wall,…
Phosphor Bronze vs Brass: Which Is Better for CNC Parts?
Phosphor bronze and brass are both copper alloys, but they are not interchangeable materials. Brass is usually easier to machine…
What Is Deburring in CNC Machining?
Deburring is the process of removing unwanted sharp edges, raised material, loose burrs, and small metal projections left after machining,…
Aluminum Anodizing Defects in CNC Parts: Causes, Prevention, and RFQ Notes
Aluminum anodizing defects are not always caused by the anodizing tank. Many problems begin earlier, during material selection, CNC machining,…
