Blog List
Profile Tolerance Across the Width of a CNC Cam Track
The inspection sketch for a milled cam block shows one scan running up the middle of the track. It follows…
Standard Drill Sizes for Clearance, Reamed and Tapped Holes
A letter E drill is already in the spindle. An aluminum fixture plate needs a through-hole for a 6 mm…
Screw Boss Design: Will the Screw Seat Before It Strips?
The CNC sample and the first molded ABS housing both accept the same cover screw. Which one should the assembly…
Casting Defects: Should This Bracket Go to Machining?
“Can we blend these marks and machine the batch?” Before answering, ask the supplier to point to each mark on…
Polypropylene vs Polyethylene: Will the Rack Insert Fit?
A removable plastic insert can fit a metal rack at room temperature and still jam after a warm wash. Machining…
Quenching and Tempering: Before or After CNC Machining?
Start with the drawing and the material specification it references. If either requires quenching and tempering after rough machining, plan…
ABS vs Polycarbonate for Machined Housings
Choose between ABS and polycarbonate (PC) for a machined housing by matching the offered stock grade to the service conditions…
Thread Size Chart for Matching CNC Parts and Fasteners
Use a thread size chart to match both nominal diameter and pitch to the mating component. In M8 × 1.25,…
Angularity GD&T: Why the Measuring Direction Matters
For a CNC wedge with a 45° seating face, the inspection scope depends on which requirement the supplier is quoting.…