Industry News
Phosphor Bronze vs Brass: Which Is Better for CNC Parts?
Phosphor bronze and brass are both copper alloys, but they are not interchangeable materials. Brass is usually easier to machine…
Industry News
What Is Deburring in CNC Machining?
Deburring is the process of removing unwanted sharp edges, raised material, loose burrs, and small metal projections left after machining,…
Industry News
Aluminum Anodizing Defects in CNC Parts: Causes, Prevention, and RFQ Notes
Aluminum anodizing defects are not always caused by the anodizing tank. Many problems begin earlier, during material selection, CNC machining,…
Industry News
Tapped Hole vs Threaded Hole: What Should CNC Drawings Specify?
A threaded hole is any hole with internal threads. A tapped hole is a threaded hole made by a tapping…
Industry News
18-8 vs 316 Stainless Steel: Which Is Better for CNC Parts?
If a CNC part only needs general stainless hardware performance, 18-8 stainless steel may be acceptable. If the part will…
Industry News
304 vs 18-8 Stainless Steel: Are They the Same for CNC Parts?
For many general stainless steel parts, 18-8 stainless steel and 304 stainless steel may look interchangeable, but they should not…
Industry News
Machining PEEK Parts: Why Tolerances Drift After CNC Machining
A PEEK part can pass inspection and still become a problem later. The bore measures correctly. The flatness looks acceptable.…
Industry News
304 vs 201 Stainless Steel: Grade Substitution, PMI Checks, and CNC Machining Risks
A stainless steel part can pass machining inspection and still become a problem after delivery. The dimensions are correct. The…
Industry News
316 vs 316L Stainless Steel: CNC Machining, Passivation, and Selection Risks
316 and 316L stainless steel look almost the same to most buyers. They also machine in similar ways. That is…
